Search results for: 'fault key'

Fluke GFL-1500 solar ground fault locator pinpoints active PV faults up to 1500V using non-contact signal tracing for faster, safer troubleshooting.

This solar ground fault locator pinpoints active PV faults up to 1500V using non-contact signal tracing and includes 1 year of Premium Care.

Tests for correct wiring, open ground, reverse polarity, open hot, open neutral, hot on neutral, hot and ground reversed with open hot and ground fault interruption in 3‑Wire, 120Volt AC.

Fluke FEV100/BASIC EVSE tester simulates an electric vehicle to verify charging station safety, run GFCI tests, and check voltage, duty cycle, and grounding.

AEMC 2620 Leakage Current Probe: Detect low-level ground and differential faults with high accuracy, large jaw opening, and DMM compatibility.

Fluke ST120+ GFCI Socket Tester quickly checks outlet wiring and GFCI function with bright LEDs, audible alerts, and simple one-button testing.

FThe Fluke 1507 is a compact, rugged insulation resistance tester offering selectable test voltages from 50 V to 1000 V, automatic Polarization Index (PI) and Dielectric Absorption Ratio (DAR) calculations, and CAT IV 600 V overvoltage rating — designed for contractors, industrial maintenance, and commissioning environments.

Fluke SOL-TI-27HZKIT combines high-efficiency PV I-V curve tracing with 27 Hz thermography for fast, accurate solar performance testing.

Fluke 368 FC clamp meter provides 1μA resolution, 60A leakage testing, wireless Fluke Connect logging, and a shielded 40 mm jaw for accurate troubleshooting.

Fluke 190-202-III-S portable ScopeMeter delivers 200 MHz bandwidth, 2 channels, 2.5 GS/s sampling, and FlukeView software for advanced industrial diagnostics.

Fluke 190-062-III-S ScopeMeter: Rugged 60 MHz 2-channel oscilloscope with intelligent triggering, FFT analysis, and built-in multimeter.

AEMC C.A 6116N Multi-Function Tester Kit: Verify electrical installations with precision—includes DataView®, clamp, and all-in-one compliance testing.

Fluke 125B/NA/S Industrial ScopeMeter combines a 40 MHz oscilloscope, dual multimeters, and bus health testing for fast industrial troubleshooting.

Fluke 1662 tester provides essential installation testing with insulation, continuity, loop, RCD and polarity checks, plus memory for storing onsite measurements.

Amprobe PRM-6 tester verifies phase sequence and motor rotation with wireless non-contact detection and CAT IV 600 V safety.

Fluke 287 CAL logging multimeter delivers True-RMS accuracy with TrendCapture graphing, onboard data logging, and NIST traceable calibration with data.

Fluke 80i-2010S measures up to 2000A AC/DC on large conductors, enabling safe current testing without disconnecting the load.

The Amprobe MO-100 Milliohm Meter offers accurate four-terminal resistance measurement with auto-hold, overvoltage protection, and a portable battery-powered design.

Fluke 190-502-III ScopeMeter delivers 500 MHz bandwidth, 5 GS/s sampling, CAT IV safety, and portable oscilloscope performance for industrial troubleshooting.

Fluke SOL-INS87-KIT delivers complete PV testing with I-V curve tracing up to 1500V, insulation testing, clamp measurements, and multimeter diagnostics.

Fluke FLK-FEV150/TY1 EV Charging Station Analyzer enables fast, safe AC EVSE testing with Type 1 connector, auto control pilot simulation, and guided workflows.