Search results for: 'maximum'

Introducing the OWON SP3101 - Your Compact Power Solution.

Introducing the OWON SP3051 - Your Compact Power Solution.

Introducing the OWON AG1022F - Precision and Versatility in Waveform Generation.

Introducing the OWON AG1022 - Your Ultimate 2-Channel Waveform Generation Solution.

Introducing the OWON XDG2100 Arbitrary Waveform Generator – Precision and Versatility at Its Peak.

Introducing the OWON XDG2080 Arbitrary Waveform Generator – Precision and Versatility at its Best.

Introducing the OWON TAO3072A 2-Channel 14-bit 70MHz Tablet Oscilloscope

Elcometer 331 TH Deep Cover Concrete Covermeter & Half Cell Gauge for reinforced concrete surveys requiring rebar location, cover depth measurement, bar sizing, and TH linear/grid data logging.

Eaton XTCEXFAC20 auxiliary contactor supports control-panel auxiliary switching with two normally open contacts and visible AC/DC ratings.

Sprecher + Schuh CS7E-31E control relay with attached CS7-PV auxiliary contact block. Rated for up to 690V AC, this 4-pole industrial control relay is used for switching control circuits in panel and machine control applications.

Beckwith M-0193 Syncrocloser Unit delivers automatic generator-to-bus synchronization with adjustable voltage and frequency difference limits for controlled breaker closing in power system applications.

Action Instruments AP9046 DC output power supply with 120VAC input, 24VDC regulated output, plug-in 8-pin design, and current loop power supply capability for two-wire transmission applications.

Fisher SONDE-8K 8.2 kHz transmitter for tracing non-metallic pipes and locating blockages. Works with TW82 and TW8800 line tracers to send a detectable signal inside pipe systems.

Fisher SONDE-512 transmitter emits a 512 Hz signal to trace non-metallic pipes and ducts. Designed for push-rod use, it works with line tracers to locate pipe paths and underground blockages.

Fisher SONDE-TW6 SR-81 is an 81.92 kHz pipe signal transmitter designed for use with TW6 line tracers. Inserted into non-metallic pipe or duct via push rod, it enables precise underground pipe tracing and blockage location.

The Fluke Networks LinkIQ LIQ-KIT-FMC Cable & Network Tester Kit verifies twisted pair and fiber performance up to 10GBASE-T and supports network troubleshooting. It provides frequency-based bandwidth validation, wiremap, distance to fault, IPv4/IPv6 ping, nearest switch diagnostics, and PoE testing, with RJ-45, USB, and SFP connectivity.

The Fluke 289/IMSK Industrial Multimeter Service Kit combines the Fluke 289 logging multimeter with the i400 400A AC current clamp. The 289 features TrendCapture logging, low ohm capability, LoZ voltage, and a low pass filter for accurate measurements on variable frequency drives and noisy systems. The included i400 clamp enables current measurement up to 400 A AC without breaking circuits.

The Phoenix Contact PSR-SCF-24UC/URM/2x21 is a safety coupling relay designed for safe switch-off applications in industrial control systems. It features two force-guided changeover contacts, 24 V AC/DC supply voltage, and supports safety category 1, PL c, and SIL 1 applications.

The Allen-Bradley 1769-IQ16 is a Compact I/O 16-point, 24V DC digital input module for CompactLogix and MicroLogix 1500 systems. It supports sinking and sourcing inputs, provides LED status indication per point, and installs via DIN rail or panel mount.

Fluke FLK2AC/90-1000V5PK VoltAlert non-contact voltage detector 5-pack senses 90–1000V AC through insulation, featuring always-on operation, battery check, and CAT IV 1000V safety rating.

Phoenix Contact QUINT-DIODE/12-24DC/2X20/1X40 is a DIN-rail mounted redundancy diode module for 12–24 V DC systems. It decouples parallel power supplies to increase system availability, supporting 2×20 A redundancy or 1×40 A increasing power operation.