Search results for: 'shafts cm'

SKF CMSS65-010-00-12-10 is a CMSS 65 series 5 mm eddy current probe with armored cable, 1/4-28 threaded fully threaded case, 3.0 cm case length, and 1.0 m overall length.

SKF TKSA 40 laser shaft alignment tool for horizontal single coupling alignment with soft foot check, alignment tolerance evaluation, internal result storage, and USB data transfer capability.

Fluke AC288 SureGrip Terminal Block Probe Set delivers safe, precise connections to spring clamp and screw terminals using retractable stainless steel probe tips compatible with 4 mm test leads.

Allows the user to insert the probe into flues and pipes that are hard to reach and in tight locations where the typical straight rigid probe is difficult to use.

Fluke 820-2 LED Stroboscope enables non-contact rotational speed diagnostics with high-intensity LED output, quartz accuracy, and sharp stop-motion imaging.

The Wohler M10 Perlon Domed Brush is built for sweeping in chimneys, flues, vents, pipes, and ductwork where a softer brush is preferred. Its domed profile helps the brush feed smoothly through the cleaning path while the perlon (nylon) bristles stay engaged with the interior surfaces for consistent soot, dust, and debris removal.

The Amprobe PRM-6 Phase Sequence and Motor Rotation Tester verifies 3-phase wire sequence and motor rotation direction in commercial and industrial electrical systems. It supports phase-to-phase voltage measurement up to 700 V and features non-contact wireless motor rotation detection for running motors. A backlit LCD display provides clear indication of phase rotation and error conditions. Rated CAT IV 600 V, the PRM-6 is designed for use on electrical systems requiring reliable phase sequence and rotation confirmation.

Elcometer 331 TH Concrete Covermeter supports rebar location, orientation, cover depth measurement, bar sizing, half-cell potential measurement, linear/grid data logging, and short borehole probe checks in reinforced concrete.

Wöhler Threaded Brush HT delivers heat-resistant cleaning reach for narrow flues, chimney pipeworks, dryer vents, and air ducts with soft  bristles, M5 threading, and a guide ball tip.