Search results for: 'minny_mou'

For testing threaded fixings when using the M2050 Pro Tester

The Hydrajaws Safety Post and Foundation Push Tester is designed to apply hydraulic pressure on a VRS safety post. This pressure is applied in increments through the use of a hand pump and its attached gauge. The distance between a set vertical datum and the safety post is then recorded at each stage.

Looking for a reliable solution to test sleeve and stud anchors? Hydrajaws Threaded Stud Adaptors are your answer! Our adaptors are specifically designed to provide accurate and efficient testing of sleeve and stud anchors, ensuring the safety and stability of your structures.

The standard red Hydrajaws Carrying case suitable for all M2000 and M2050 kits (filler ordered separately).

For testing Hex bolts when using the M2050 PRO Tester.

Looking for a reliable solution to test sleeve and stud anchors? Hydrajaws Threaded Stud Adaptors are your answer! Our adaptors are specifically designed to provide accurate and efficient testing of sleeve and stud anchors, ensuring the safety and stability of your structures.

New for 2022 the M0097 Carry Case is lighter and more convenient. Includes inlay and document holder.

The Hydrajaws Pyramid Load Spreading Bridge offers greater stability and a wider area for unconfined testing on rough ground.

For testing Hex bolts when using the M2050 PRO Tester.

Drive: 1/4"/6.3mm Square Unit: N-m/lbf.in Dual units Torque Range: 5.0~25 N-m/ 53~212 lbf.in Accuracy: +/-3.0 % Graduation: 0.2 N-m Gear teeth: 64 T OAL: 9.8"

Drive: 1/4"/6.3mm Hexagon Unit: N-m/lbf.in Dual units Torque Range: 1.0~6.0 N-m Accuracy: +/-6.0% Graduation: 0.1 N-m/lbf.in OAL: 7.9"

1 x Hydrajaws Threaded Stud Adaptor

Compact, cordless design for portability Safety cap turns off device when in place Heats up to temperature in 15-20 seconds Temperature up to 450°C/840°F Maintains soldering temperature at least 300°C/600°F Lead free solder wire (Ø1mm ) included Requires 3 x AA Batteries (not included)