Search results for: 'fiber tools'

FTTH Innovations FIG air blown microfibre installation tool with electronic push force control and cruise control mode for controlled fibre installation in microduct at speeds up to 100 m/min.

The INNO Instrument SC-SM-UPC-30S is a 10-pack of SC single-mode UPC splice-on connectors designed for 3.0mm jacketed fiber. Using fusion splice termination, these short boot SOC connectors provide stable optical performance without field polishing or index-matching gels.

The INNO Instrument UN1COLK UN1CO Ladder Mount Work Platform is an ABS workstation designed for secure positioning on ladder rungs during fiber splicing operations. It provides a stable surface for INNO View series fusion splicers and common industry cleavers in elevated or confined environments.

INNO Instrument FH-Single Fusion Series fiber holder for 900 µm single fiber in detachable M Series fusion splicer applications.

The INNO Instrument SC-SM-APC-30S is a 10-pack of single-mode SC/APC splice-on connectors designed for 3.0mm fiber cables. Featuring a short boot configuration, these pre-cleaved and pre-polished connectors enable fusion-spliced terminations using compatible INNO Instrument fusion splicers.

The INNO Instrument SC-SM-UPC-30 is a 10-pack of SC/UPC single-mode splice-on connectors designed for 3.0mm fiber cables. Each connector is factory pre-cleaved and pre-polished to support consistent optical performance, with typical insertion loss of 0.15 dB and return loss ≥55 dB.

The INNO Instrument HTS-SOC-01 is a heater cover accessory designed for use with compatible INNO fusion splicers. It replaces the standard heater cover to support splice-on connector (SOC) termination workflows where connector geometry requires an alternate heater configuration.

INNO Instrument FH-12F Fiber Series ribbon fiber holder for 12-fiber flat ribbon cable, supporting 200 µm and 250 µm coatings and compatible with View12R, View12R-200, and View12R PRO detachable setups.

The INNO Instrument FH Series Ribbon Fiber Holders are detachable accessories designed for use with INNO fusion splicers such as the View4M and View12R. These holders secure and align ribbon fibers during preparation and splicing, supporting configurations from 2-fiber to 12-fiber ribbons with 250µm coatings.

The INNO Instrument Ribbon Holder are fiber ribbon holders designed for use with INNO Instrument View12R and View12R PRO fusion splicers. The holder supports 250 µm ribbon fiber during the splicing process, maintaining fiber alignment and stability within the splicer. Its detachable design allows quick installation and removal when preparing ribbon fibers for fusion splicing.

INNO Instrument FH-SOC fusion splicer SOC holder for use with compatible INNO Instrument fusion splicers, including View 12R, View 12R PRO, View 3 PRO, and M Series.