Search results for: 'heats'

The INNO Instrument IN-RS-40mm ribbon fiber splice protection sleeve is a 40 mm heat-shrink sleeve designed to protect ribbon fiber fusion splices. The sleeve incorporates a single ceramic reinforcement rod for structural support and alignment protection after splicing. A clear heat-shrinkable outer tube combined with an internal EVA adhesive liner.

The INNO Instrument IN-RD-40mm ribbon fiber protection sleeve provides environmental and mechanical protection for ribbon fiber fusion splices. The 40 mm heat-shrink sleeve incorporates a double ceramic rod structure that maintains alignment and rigidity during the shrinking process.

The INNO Instrument IN-SS-60mm fiber splice protection sleeves provide mechanical reinforcement for fusion-spliced optical fibers. Each 60 mm sleeve uses a clear heat-shrink polyolefin outer tube, internal adhesive liner, and stainless steel strength member to support fiber alignment after the splicing process.

The INNO Instrument TS Pro Thermal Stripper is designed for removing coating and jacket from optic fibers, supporting single fiber up to 12 ribbon fibers. It accommodates coating diameters from 200 μm to 400 μm and provides selectable heating modes with controlled temperature settings.

The INNO Instrument IN-SS-40mm fiber splice protection sleeve is a 40 mm heat-shrink sleeve designed to reinforce single-fiber fusion splices. A stainless steel strength member helps prevent bending while the clear outer tube allows inspection of the splice during installation.

The INNO Instrument IN-SS-45mm fiber splice protection sleeves are heat-shrink sleeves designed to reinforce and protect single fiber fusion splices. Each sleeve uses a composite structure consisting of a cross-linked polyolefin outer tube, hot-melt adhesive inner layer, and stainless steel reinforcing rod.

The INNO Instrument HTS-SOC-01 is a heater cover accessory designed for use with compatible INNO fusion splicers. It replaces the standard heater cover to support splice-on connector (SOC) termination workflows where connector geometry requires an alternate heater configuration.

The INNO Instrument SC-SM-APC-09 is a field-installable SC/APC singlemode splice-on connector supplied in 10 a pack. Designed for fusion splicer termination, the connector houses and protects the fusion splice within the connector body, eliminating separate splice trays. The cleaved and polished ferrule supports repeatable field assembly.