Search results for: 'maximum'

FTTH Innovations FIG air blown microfibre installation tool with electronic push force control and cruise control mode for controlled fibre installation in microduct at speeds up to 100 m/min.

The INNO Instrument SC-SM-UPC-30S is a 10-pack of SC single-mode UPC splice-on connectors designed for 3.0mm jacketed fiber. Using fusion splice termination, these short boot SOC connectors provide stable optical performance without field polishing or index-matching gels.

The INNO Instrument SC-SM-UPC-30 is a 10-pack of SC/UPC single-mode splice-on connectors designed for 3.0mm fiber cables. Each connector is factory pre-cleaved and pre-polished to support consistent optical performance, with typical insertion loss of 0.15 dB and return loss ≥55 dB.

The INNO Instrument IN-RS-40mm ribbon fiber splice protection sleeve is a 40 mm heat-shrink sleeve designed to protect ribbon fiber fusion splices. The sleeve incorporates a single ceramic reinforcement rod for structural support and alignment protection after splicing. A clear heat-shrinkable outer tube combined with an internal EVA adhesive liner.

The INNO Instrument SC-SM-APC-30 is a 10-pack of SC-type single-mode splice-on connectors designed for 3.0mm fiber cables. Featuring APC polish and pre-polished factory ferrules, these connectors support fusion splice termination with low insertion loss and high return loss performance.

The INNO Instrument SC-SM-APC-30S is a 10-pack of single-mode SC/APC splice-on connectors designed for 3.0mm fiber cables. Featuring a short boot configuration, these pre-cleaved and pre-polished connectors enable fusion-spliced terminations using compatible INNO Instrument fusion splicers.