Fujikura 90S+ with CT50 Fiber Cleaver Single-Fibre Core Alignment Fusion Splicer

The Fujikura 90S+ Core Alignment Fusion Splicer helps fiber installation and repair teams address low-loss splicing, consistent alignment, and fast sleeve protection in the field. It aligns fiber cores, performs automated fusion splicing, and supports heat-shrinkable protection sleeve processing across supported single-mode and multi-mode optical fibers.

• Active core alignment positions fiber cores before arc discharge, enabling controlled fusion splicing across supported optical fiber types.
• The automated wind protector, sheath clamp, and tube heater carry the splice sequence from fiber positioning through protection sleeve heating.
• Active Fusion Control adjusts arc behavior during splicing, supporting splice performance when fiber end-face conditions vary.
• The universal sheath clamp supports loose and tight buffer fiber handling without changing clamp components.
• A built-in tensile test applies approximately 2.0 N after splicing to check splice integrity during the workflow.

• Single-fibre splicing supports cladding diameters from 80 μm to 150 μm and sheath clamp coating diameters up to 3000 μm.
• Typical splice loss is listed at 0.02 dB for ITU-T G.652, 0.01 dB for ITU-T G.651, and 0.02 dB for ITU-T G.657 fiber.
• SM FAST mode splice time is listed at an average of 7 to 9 seconds.
• Heat-shrinkable sleeve processing supports sleeve lengths up to 66 mm and sleeve diameters up to 6 mm before shrinking.
• Data storage includes 100 splice modes, 30 heat modes, 20,000 splice results, and 100 splice images.

• Supports distribution fiber repair and outside plant cable installation or repair.
• Supports long-haul network installation and access network installation.
• Supports field termination workflows using splice-on connectors, pigtails, splice cassettes, fanout kits, and optical modules.