Search results for: 'head zzz an'

Trend Networks LanTEK IV-500 R163000 Certified Pre-Owned Cable Certifier Kit with CAT6A VisiLINQ Adapters, Fiber Inspection Microscope Support, Tone Test and TeamViewer Remote Control Tools. Includes Main + Remote Units and Carry Case.

Static dissipative mat for workstation Heat tolerance: 70° C Resistivity Face & Center & Bottom Layers: 10M~1KMΩ/SQ Combination layer: 1K~1MΩ/SQ, Static decay time: < 0.5sec

Replacement Tip For 3.2D type (I.D.:4.0mm, O.D.:6.3mm)

Replacement Nozzle for SS-989A PLCC Single 21x21 ID 22mm

Tests for correct wiring, open ground, reverse polarity, open hot, open neutral, hot on neutral, hot and ground reversed with open hot and ground fault interruption in 3‑Wire, 120Volt AC.

Replacement Tip For 1.6D type (I.D.:4.0mm, O.D.:6.3mm)

Silicone sleeve assure precise control Spring-tensioned nozzle 3 - 5 minute heat up time 14-16g glue flow per min 120V, 30-80W

Replacement Nozzle for SS-989A/SS-989ESingle F6.6 ID 22mm

Replacement Hot Air Gun Heater Element For SS-989E.

4 -1/2" Made of PC Carbon Fiber, these tweezes are also non-metallic, acid resistant, and heat resistant. The Flat tip allows the user to pick up wider surfaces.

Sharp angles allow for use in extremely shallow spaces. The material is acid resistant, heat resistant, and non-metallic, meaning it does not conduct electricity.

Replacement Nozzle for SS-969E, 0.18"

Compact, cordless design for portability Safety cap turns off device when in place Heats up to temperature in 15-20 seconds Temperature up to 450°C/840°F Maintains soldering temperature at least 300°C/600°F Lead free solder wire (Ø1mm ) included Requires 3 x AA Batteries (not included)

Made of PC Carbon Fiber and only 4.5" long, these tweezes are also non-metallic, acid resistant, and heat resistant.

Replacement Tip For K type (I.D.:4.0mm, O.D.:6.3mm)

Replacement Tip For 2C type (I.D.:4.0mm, O.D.:6.3mm)

Replacement Tip For B1.0 type (I.D.:4.0mm, O.D.:6.3mm)

Eclipse Tools Replacement Nozzle for SS-989A - This specialized nozzle is designed for QFP single components with an ID of 15.2x21.2 and a length of 22mm. It's an essential component for your SS-989A soldering station, ensuring precise and efficient soldering for QFP components.